Light up the night! Offering 360° illumination with 4 bright colours (white, red, blue, pink) and 2 light modes (solid and flashing), the eye-catching Nova LED Light Harness is a comfortable everyday harness that will keep your pup visible in low-light conditions, allowing you to safely enjoy adventures together at any time!
Explore the details
-
4 colour options (white, red, blue, pink) and 2 light modes (solid and flashing)
-
USB rechargeable - includes micro-USB charging cable
-
Battery lasts from 3 to 10 hours depending on colour and light mode used
-
Easy step-in design with 4 points of adjustability
-
Breathable air mesh fabric for air circulation and comfort
-
Reflective details for additional visibility
-
Light component is waterproof rated to IPX5 – capable of withstanding light to moderate rain
-
This product may not be charged at time of purchase.
- SIZING
- HOW TO FIT
- HOW TO USE
- CARE / MATERIAL
- in
- cm
Size
Girth
S
M
L
XL
18" - 22
20" - 28
25" - 35"
30" - 40"
Size
Girth
S
M
L
XL
45.5 - 56 cms
51 - 71 cms
63.5 - 89 cms
76 - 101.5 cms
- Stand your dog on top of a hard surface
- Use a soft measuring tape to measure your dog's girth (the widest circumference around your dog’s chest)
- Select the harness size from the chart above that best matches your dog's girth measurement
- If the measurement falls between two sizes, it's recommended to opt for the larger harness size to ensure your pet's comfort.
- Ensure lightbox is securely attached to harness back webbing using the wide mouth clip located on the back of the lightbox.
- Slide all four (4) light wand extensions into the wand casings of the harness. Important: Not all light wand extensions are the same length. To avoid damaging the want casings, refer to diagram.
- Open the buckle closures of the harness.
- Use the sliders to loosen the default settings on the neck, girth and chest straps.
- Put your dog's right front paw through the leg opening of the harness.
- Wrap harness around your dog’s back, closing the buckles on left side.
- Adjust the sliders so the harness fits snug but allows for 1-2 fingers of room between the straps and your dog’s body.
HOW TO USE
- Press bottom button once to turn on.
- Single press to switch between colours and light modes.
- To turn off, press and hold for 2 seconds.
HOW TO CARE
- The product contains a rechargeable lithium battery. Do not remove it from the product.
- Use the micro-USB cable provided to charge the light device (power adapter not included).
- Check the charging cable before use. Using damaged cables or chargers or charging when moisture is present can cause fires, electric shock, injury, death, or damage to property.
- Make sure the charging cable is fully inserted into the power adapter when charging.
- Do not allow pets to wear this product while charging.
- Red light flashes during charging. Green light indicates a full charge. Note that a full charge takes approximately 3 hours.
- Charge product in a ventilated area at temperature between 50 F and 90 F (10 C and 32 C).
- The USB charging cord supplied with this product is standard with 5 V dc voltage and a current of .5 A or 500 mA.
LIGHT COMPONENT CLEANING
INSTRUCTIONS
- To clean this product, remove the light component from the harness and use a damp cloth to clean it.
- Do not submerge the light component in water.
- Store product where ambient temperatures are within -4 F to 95 F (-20 C to 35 C).
HARNESS CLEANING INSTRUCTIONS
- Harness component can be machine washed on gentle cycle. Ensure buckles are fastened before placing in the washer.
RECYCLING INSTRUCTIONS
- Light component can be recycled at an electronic recycling centre at the end of product's life.
LIGHT COMPONENT CLEANING INSTRUCTIONS
- To clean this product, remove the light component from the harness and use a damp cloth to clean it.
- Do not submerge the light component in water.
- Store product where ambient temperatures are within -4 F to 95 F (-20 C to 35 C).
HARNESS CLEANING INSTRUCTIONS
- Harness component can be machine washed on gentle cycle. Ensure buckles are fastened before placing in the washer.
RECYCLING INSTRUCTIONS
- Light component can be recycled at an electronic recycling centre at the end of product's life.
Machine wash cold
do not iron
Hang to Dry
do not bleach
MATERIAL
BODY: 100% POLYESTER AIRMESH
WEBBING: 100% NYLON
UPPER LAYER: 100% POLYESTER
HARDWARE: ALUMINUM ALLOY
LIGHT CASING: PC (POLYCARBONATE)
BODY: 100% POLYESTER AIRMESH
WEBBING: 100% NYLON
UPPER LAYER: 100% POLYESTER
HARDWARE: ALUMINUM ALLOY
LIGHT CASING: PC (POLYCARBONATE)
×
